MEANWell NEL-400-5 Switching Power Supply Manufacturer.
Taille:215×115×30mm.
Pouvoir: 400W.
Haute efficacité jusqu'à 90%.
Fonction PFC active intégrée, PF>0.95.
Indicateur LED pour la mise sous tension.
Forced air cooling by built in DC Fan with fan speed control function.
1U profil bas 30mm
Haute efficacité, Long life and high reliability
Protections: Court-circuit / Surcharge / Surtension / surchauffe
1 an de garantie
MEANWell NEL-400-5 Switching Power Supply Manufacturer Product Specifications :
| Modèle | NEL-400-5 | |
| Saisir | Plage de tension | 85~ 264VAC 120~ 370VAC |
| PLAGE DE FRÉQUENCES | 47 ~ 63 Hz | |
| COURANT AC (Typ.) | 3.5A/115VAC 1.5A/230VAC | |
| COURANT DE FUITE | <2mame / 240ACC | |
| COURANT D'APPEL (Typ.) | COLD START 65A/230VAC | |
| EFFICACITÉ (Typ.) | 84% | |
| Sortir | COURANT NOMINAL | 80UN |
| TENSION CC | 5V | |
| PUISSANCE NOMINALE | 400W | |
| GAMME ACTUELLE | 0-80UN | |
| AJUSTEMENT TENSION. GAMME | 4.5~ 5.5V | |
| ONDULATION & BRUIT (maximum.) Remarque.2 | 150mVp-p | |
| TOLÉRANCE DE TENSION Note.3 | ±2,0% | |
| LOAD REGULATION Note.5 | ±1.5% | |
| LINE REGULATION Note.4 | ±0,5% | |
| TENIR LE TEMPS | 20ms at full load | |
| INSTALLATION, TEMPS DE MONTÉE | 600MS,40ms at full load | |
| Protection | OVER VOLTAGE | 5.6~ 7V Mode de protection :Shut off 0/p volltage, clamping by zener diode |
| OVER LOAD | Above 150% rated output power Mode de protection :Hiccup mode, recovers automatically after fault condition is removed |
|
| Sécurité | RÉSISTANCE À LA TENSION | I / P-O / P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC |
| SAFETY STANDARDS Note 6 | UL60950-1, Cb(IEC60950-1),CCC GB4943, 1:2011 approuvé | |
| RÉSISTANCE À L'ISOLEMENT | I / P-O / P, I / p-fg, O / P-FG:100M Ohms / 500VCC / 25 / 70% Rh | |
| NORMES CEM | EN55022 class B, EN61000-3-2,3, EN61000-4-2,3,4,5,6,8,11, GB9254 | |
| Environnement | HUMIDITÉ DE TRAVAIL | 20 ~ 90% RH sans condensation |
| TEMPÉRATURE DE TRAVAIL | -20 ~ +70 (Se référer à la courbe de déclassement de la charge de sortie) | |
| TEMP.. COEFFICIENT | ± 0.03% | |
| TEMP. DE STOCKAGE., HUMIDITÉ | -40 ~ +85 , 10 ~ 95% Rh | |
| VIBRATION | 10 ~ 500Hz, 2G 10min./1cycle, 60min. chacun le long de X, Oui, Axes Z | |
| Autres | DIMENSION | 215*115*30MM (L*L*H) |
| Mtbf | 1608.8K heures min. MIL-HDBK-217F (25 ) | |
| Note | je. Al parameters NOT specialy mentioned are measured at 230VAC input. charge nominale et 25??de la température ambiante. 2 Ondulation & noise are measured at 20MHz Of bandwidth by usig a I2??twisted pair-wire terminated with a 0.1UI & 470 Parallel capacitor 3. Tolérance : includes set up tolerance. régulation de ligne et régulation de charge. 4. Line regulation is measured from low line to high line at rated load. 5. Load regulation is measured from 0% à 100% rated load. 6. For the request of GEl4943.1.the power soppy is only suable for use in the altitude 2000m below and the non tropical climate condrtion. 7. The power supply is considered a component which will be instated into a final equipment The final equipment must be re-confirmed that it still mesh EMC drectives. For guidance on how to perform the EMC tests. please refer to ‘EMI testing of component power supplies. |
|
